My shopping cart
Your cart is currently empty.Continue Shopping
As their owners know, these knives are super useful, but if they have one downside it's that they tend to get VERY dirty and can be extremely difficult to clean.
Fortunately, Knife Pivot Lube has a secret method for getting your SAK as clean and smooth as it was when you got it from the factory!
Inspect the inside of your knife so you know where things stand before you get started then grab a Nalgene bottle and fill it about halfway with warm water. Add 4-5 drops of liquid dishwashing soap to water in your Nalgene and top off the mixture with a few tablespoons of Borax powder.
It's important to use a dishwashing soap that will rinse clean and not leave behind residues in the joints of your knife. Once your cleaning mixture has been prepared, open the stouter tools on the knife so the wash water can better access the internals of your knife. Make sure that the blades and more fragile tools like scissors remain closed.
Next insert the knife into the Nalgene bottle, close the lid, and shake vigorously for 30-40 seconds. As you shake the bottle, dirt, grease, and contaminants are being removed from the knife and stuck-on grit is loosened by the detergent.
Now remove your knife from the bottle and rinse well with clean water. If possible, empty and refill your Nalgene bottle with clean water and give the knife another wash, this time with pure water.
Once you've given the knife a wash to remove most of the dirt and grime, you'll want to dry the knife very well to prevent rust from corroding the knife, especially in the tight crevices and pivots of each of the tools.
To do this very effectively, you can use high proof alcohol to pull moisture out of the knife. Use either Ethanol or Isopropanol (Isopropyl alchohol) with 90% or greater alcohol content. Pour or spray alcohol into the body of the knife, dry with a rag and allow the knife to sit for a few minutes while the alcohol evaporates.
First of all, you'll want to remove debris and dirt. In order to make sure no residual dust or particles fall into the pivot, be sure to first wipe the knife down with a light plastic/nylon brush (old toothbrushes are great for this), and follow with a moist microfiber cloth.
Use cotton swabs to remove dirt and grit in the slots of the knife, paying attention to the areas near the pivots. If necessary, use a flashlight to illuminate the workspace!
Luckily, since you are working with a traditional folder, there's nothing for you to tear down! Case knives are meant to stay in one piece! Since you're not disassembling your knife, you need to be certain you use a separating parts, your lubricant penetrates deeply, reaching every surface and interface.
Apply a drop or two of lubricant to the pivot of each blade (be sure to get all pivot points, work the blades of your knife open and shut several times, then swab away excess lubricant with a cotton swab.
In addition to the pivots, I'm always sure to add a bit of lubricant to all steel parts. This includes any locking mechanism (if there are any). Applying a bit to the blade, where the blade rests, and pins with a q-tip can displace moisture and prevent rust. It also keeps the metal fresh and healthy. Be sure to also clear the locking mechanism of any debris, and apply some extra lubricant for good measure.